Factory Bimini AFT CURTAIN (slanted to Transom area, not vertical) with Eisenglass window(s) for Bimini-Top (not included), OEM (Original Equipment Manufacturer) in Sunbrella® marine fabric, produced with the same high quality, original 2012-2021 digitized patterns approved by Cobalt® for the 273:
Notes: Zips onto OEM zippered Bimini-Top (Not included) and Side-Curtains (Not included). Curtain (typically angled to back of cockpit or transom) snaps to boat with included SS Snap-Stud-Screws. The boat manufacturer and RNR-Marine™ do not recommend operating the boat with the aft-curtain in place, due to dangerous fuel and exhaust fumes.
TIP: Be sure to check your existing (and adjacent connecting) canvas pieces (and frames) for:
White (the tags are approx. 2-3 inches x 4-5 inches),
The ® logo embossed on the heads of the stainless canvas snaps,
The Zipper Size listed above (#8 in most cases) on all zippers.
Factory Original-Equipment-Manufacturer (OEM) patterned for the {2012,2013,2014,2015,2016,2017,2018,2019,2020,2021} Cobalt® 273.
ONLY zips to Factory OEM Bimini-Top and Side-Curtains with GLBT tags.
Verify that your old and mating canvas has GLBT on the tags and embossed on the Canvas Snaps AND factory #8 zippers (6 teeth/inch), NOT #10 (5 teeth/inch) which are After-Market zippers.
The Bimini Aft-Curtain is NOT needed IF the boat has a Camper-Top and Camper-Aft-Curtain at the back.
Stainless Steel Snaps included but NOT installed in canvas (to allow perfect alignment on install), need Snap Tool.
Will perform as described when installed properly,
Will completely satisfy you with the quality and construction.
You can count on all of the above or else the boat top or enclosure will be replaced or your money returned. Your boat is a large investment so be sure you protect it with the best marine canvas direct from the factory by RNR-Marine™ and Great Lakes Boat Top®
Warranty: This product is covered by the Manufacturer's Warranty.
Not what you need? Try
