Join seams are folded four-ply (no raw edges) and sewn with double-stitches using weather resistant anti-wick thread for added strength and durability,
TRAILERABLE when tied-down securely with optional #61001 Tie-Down Straps (below),
Tie-Down Loops (every 3-4 feet) double sewn in an offset "V" for strength and less strap twisting to attach Tie-Down Straps or Sand-Bags (below),
1/4" Stretch Cord sewn into hem to pull tight to secure cover under rub rail,
MOTOR COVERS are sewn into outboard (O/B) model boat covers (some designs have separate motor cover).
Size/Fit: Fits 1971-1972 MFG® Fishin Caprice O/B,
V-Bow/V-Hull Center Console (up to 54 inch), High Bow Rail fishing boat; Single O/B,
NO T-Top; No Trolling Motor; Max Bow Rails: 17-18ft=16-inch, 18ft+=18-inch; Bimini Lowered; Buy Longer Cover for JACK PLATE; Motor Cover attached
Cover is GUARANTEED TO FIT this specific year/make/model boat setup,
Bimini-Tops must be lowered and stored flat or removed (unless stated otherwise),
Pedestal Seats must be removed or lowered,
Does NOT FIT THE FOLLOWING UNLESS SPECIFICALLY STATED IN BOAT DESCRIPTION: Other boat models or years (it MAY fit other boats, but we cannot guarantee fit), Wakeboard Tower, Folded or Upright Bimini-Top, Radar Arch, Camper-Top, T-Top, Hard-Top, Ski Tow Pylon, Non-Integrated Swim Platform, Bow or Stern Mounted Trolling Motor, Raised or protruding antennas, brackets, winches, mirrors, rod holders, etc.,
Will NOT fit ANY NON-Factory-Installed Arch, Tops or Wakeboard Tower even though they may be the OEM part as the installer may have installed it in a different location,
This is NOT a Mooring-Cover. It is a full Boat-Cover designed for use on a trailer or dry stack (or float dock or lift IF it can be pulled tightly enough at the rear). It does NOT have openings for Mooring Lines (a local shop can add slits for lines),
IMPORTANT: Boat covers must be properly installed and tied down with optional #61001 Tie-Down Straps (below, 2 sets for boats over 20 foot) connected to double "V" loops along bottom edges of the cover for trailering.
Installation: Cover is rolled and packaged with the bow end of the cover to the outside. The tag on the bow end is sewn into the inside hem of the cover. Start at the bow and follow these instructions: Carver® Boat Cover Installation Instructions.
Shipping Notes: Signature required for delivery on orders over $500. Can NOT ship to Post Office (PO) Box. Can NOT change your address after order is placed. Buyer is responsible for all Taxes, Duties and Tariffs imposed by local governments. Use a US48 Based (Florida or New Jersey) Freight Forwarder to ship outside US. Check shipment for damage upon receipt and file claim with shipper.
RNR-Marine® has the lowest prices on the Internet for Carver® Styled-To-Fit™ Boat Covers!
We have Carver® Styled-To-Fit™ Boat Covers for (119) different MFG® boat models, including the boat-cover pattern specifically for 1971-1972 MFG® FISHIN CAPRICE, O/B (outboard) (NO Raised Bimini)