Westland® p/n 5074TTCA Small (48-inch Wide(W) x 57-inch Deep(D) x 67-inch High(H), 210-inch Maximum Base Perimeter Center Console & Helm Seat WITH T-Top) Universal (non-OEM) Center Console Cover for Boat With T-Top, Sunbrella® fabric:
Notes: The Westland® T-Top Console Cover will protect the center console, steering wheel, helm, gauges, leanng post or helm seat and front cooler seat (p/n 5075TTC) from the sun's harmful and damaging UV rays, rain and bird poo.
Specifically designed to attach to the below your T-Top and will cover any console size with a base perimeter of up to 250 inches (approximately 21 feet),
Covers center console, steering wheel, helm, gauges and leanng post or helm seat (p/n 5074TTC) as well as front cooler seat (p/n 5075TTC),
Adjustable straps allow you to tightly secure the cover around your console and T-Top frame,
Zippers down the port and starboard sides,
Made of Sunbrella® or Outdura® fabric (the most durable, color-fast and long lasting marine fabric available) which breathes to resist mold and mildew inside the cover, unlike polyester or vinyl covers which hold moisture in,
Made-to-order in the USA and shipped from Westland® Covers, Inc.
Size/Fit:48-inch Wide(W) x 57-inch Deep(D) x 67-inch High(H), 210-inch Maximum Base Perimeter Center Console & Helm Seat WITH T-Top
Fits Center Console WITH a T-Top (see sketch at right for fit dimensions):
Part number 5074TTC covers the Console and Helm Seat (up to 57" depth from front of Console to Back of Helm Set),
Part number 5075TTC covers the Console, Helm Seat and front Cooler Seat (up to 77" depth from front of Cooler Seat to back of Helm Set),
Adjustable straps allow you to tightly secure the cover around your console and T-Top frame for the best fit possible,
Does NOT cover a front cooler or front cooler seat,
This is NOT a factory OEM cover, so measure your Center Console carefully because this cover is Made-To-Order and there are NO cancellations, refunds or returns.
Options: Two Sizes to pick from (and other options offer more protection):
POSITION YOUR COVER: Position the cover so the ZIPPER will be on the STARBOARD side of the console. At the top of the zipper will be a 24 inch strap with a buckle. Use this strap to go up over the T-Top frame on your boat. Then zip the Zipper up. The PORT side of the cover also has a 24 inch strap to be used on that side.
ADJUST THE LENGTH OF YOUR COVER: Once the cover has been attached and zipped around the console and helm seat, adjust both of the 24 inch straps until the cover just reaches the floor of the boat.
TIGHTEN THE BACK STRAPS: The cover has (3) 48 inch straps that cross the back panel of the cover behind and on top of the helm seat. These need to be adjusted to allow some of the slack to be pulled behind the helm seat. Start with the lowest one and tighten to improve fit.
SECURE THE WEATHER FLAP: Now that the straps are in place, you can secure the weather flap that is sewn to the front panel OVER the windshield bar and across the top of the console. This panel will fasten to the buckles attached to the outside of the cover over the helm seat. Adjust these straps to allow this flap to cover the opening over the console.