Factory Snap-On VINYL fabric BOW COVER (also called Tonneau Cover) with Adjustable Aluminum Support Pole and reinforced Snap for Pole Alignment in Center of Cover, OEM (Original Equipment Manufacturer) in Vinyl fabric, produced with the same high quality, original - digitized patterns approved by ® for the :
Notes: Covers open bow area. Comes with Adjustable Aluminum Support Pole with Snap or Grommet (hole) through reinforced area in center of Bow-Cover. Bow-Cover has 25 to 60 standard 3/8" snaps, depending on the boat. Includes Male Snap-Stud-Screws. Factory Original-Equipment (OEM) cover made-to-order. If purchased alone the Bow Cover ships in 43x12x5 inch box weighing approximately 5 pounds.
Size/Fit: Stainless Steel Snaps included but NOT installed in canvas, Snap Tool required. This will allow for a perfect field fit when replacing existing canvas (when male snaps are already installed on boat).
100% Guarantee: We guarantee our mooring covers, bow covers, cockpit covers, bimini tops, camper tops, and other marine canvas enclosures
Will fit your boat to the specs provided,
Will match your existing GLBT canvas,
Will perform as described when installed properly,
Will completely satisfy you with the quality and construction.
You can count on all of the above or else the boat top or enclosure will be replaced or your money returned. Your boat is a large investment so be sure you protect it with the best marine canvas direct from the factory.
Warranty: This product is covered by the Manufacturer's Warranty.