Factory Snap-On COCKPIT-COVER with NO Cutouts for Bimini or Camper top frames to pass thru, with Adjustable Support Pole(s) fitting into reinforced Snap(s) or Grommet(s), OEM (Original Equipment Manufacturer) in Sunbrella® marine fabric, produced with the same high quality, original - digitized patterns approved by ® for the :
Notes: NO Cutouts for top frame to pass through. Snaps tightly over the Cockpit area. Comes with one or two (depending on size) Adjustable Aluminum Support Pole(s) with Snap or Grommet through reinforced area in center of Cockpit-Cover. Cockpit-Cover has 30 to 80 standard 3/8" snaps, depending on the boat. Includes Male Snap-Stud-Screws. Factory Original-Equipment (OEM) cover made-to-order.
Size/Fit: Only fits Factory-Original Windshield, Arch/Tower (if so equipped) setups. Snaps included but NOT installed in canvas, so a Snap Installation Tool is required. The Cockpit-Cover does NOT have cutouts for top frames to pass through. Sea Ray® is the ONLY boat mfgr that offers a choice in Cockpit-Cover Cutouts. Typically ships in a 42inch x 25inch x 7inch Box weighing approximately 38pounds.
100% Guarantee: We guarantee our mooring covers, bow covers, cockpit covers, bimini tops, camper tops, and other marine canvas enclosures
Will fit your boat to the specs provided,
Will match your existing GLBT canvas,
Will perform as described when installed properly,
Will completely satisfy you with the quality and construction.
You can count on all of the above or else the boat top or enclosure will be replaced or your money returned. Your boat is a large investment so be sure you protect it with the best marine canvas direct from the factory.
Warranty: This product is covered by the Manufacturer's Warranty.