Factory Camper AFT CURTAIN with clear Eisenglass windows zips to back of OEM Camper Top and Side Curtains (not included) and connects to Transom, OEM (Original Equipment Manufacturer) in Sunbrella® marine fabric, produced with the same high quality, original - digitized patterns approved by ® for the :
Notes:
- ® Model Specific Details: - ® .
Product Details: Camper Top is an enclosure attached to the back of a Bimini, Sunshade, Convertible Top or Arch that has its own frame to cover to the back of the boat. Includes mounting hardware and Stainless Steel Snaps. When combined with Side-Curtains, the Camper-Top-Aft-Curtains fully enclose the back of the boat providing full, protected use of the rear cockpit area at the dock or underway. Snaps NOT installed in canvas, Snap Tool required. The Aft-Curtain has 25 to 60 standard 3/8-inch snaps or bungee cords, depending on the boat. Factory Original Equipment Manufacturer (OEM) canvas made-to-order and shipped from Boatswains Locker® . The boat manufacturer, (No Suggestions)) and Boatswains Lockers® do not recommend operating the boat with the aft-curtain in place, due to dangerous fuel and exhaust fumes.
® Factory Original Equipment Manufacturer (OEM) Notes: Unfortunately, we do not have any factory OEM canvas for blank® boats.
Size/Fit: ONLY zips to Factory OEM Camper Top and Side Curtains. Verify BLI tags. Will not fit after-market top canvas. Stainless Steel Snaps included but NOT installed in canvas (to allow perfect alignment on install), need Snap Tool. Includes Mounting Track or Zipper and Snap-Stud-Screws.
Guarantee: RNR-Marine™ and BLI® (the manufacturer) guarantee that our factory original equipment manufacturer (OEM) tops, visors, curtains, bow covers, cockpit-covers, mooring-covers and other factory original-equipment marine canvas:
Will be made using the most current digitized patterns approved by the boat manufacturer for the specified model based on the boat's actual production date identified by the last 4 digits of your Hull-Identification-Number (HIN) (and for Sea Ray® boats: the Sea Ray® Hull-Production-Number located below the HIN on the Starboard side of your transom),
Colors, changes or improvements to fasteners, materials and assemblies will be done for the most part up-to-date for the boat model,
We cannot guarantee fit due to outside installation sources, color or changes that may have been done after the boat left the factory,
Will not have fasteners installed - they are included in a separate hardware pack,
We guarantee the quality of workmanship and materials, and we will resolve quality issues found upon delivery by repairing or replacing (at our discretion) the canvas, frame or cover in question.