Notes:Carver® has made boat covers in South Carolina, USA for 40+ years:
This cover was patterned for this specific STYLE, length, width and setup of boat, so it is GUARANTEED TO FIT or we will replace it or have it returned for a refund (https://dealerguide.carvercovers.com /mmy /boat).Be sure this is your exact year, make and model boat, because this cover is subject to a 35% restocking fee,
1/4" Stretch Cord in hem (NO Snaps or Clips) pulls cover tightly under your rub rail,
TRAILERABLE at reasonable highway speeds when cinched tightly with (12) FREE Heavy Duty TIE-DOWN STRAPS (6 on smaller covers) connected to the Sturdy TIE-DOWN-LOOPS (every 2 feet, double sewn in an offset "V" for strength),
Can also be used on drive-on FLOAT, DRY-STACK, SEA-PEN or IN-WATER (Not on a LIFT) with optional Sand Bags (below), but there are NO openings for lines to your cleats,
Offered in three solution dyed fabrics (rather than just dyed on the surface, to reduce fading):
DOUBLE-STITCHED using weather resistant anti-wick thread and FOLDED FOUR-PLY JOIN SEAMS (no raw edges) for added strength and durability,
MOTOR COVER sewn into outboard model boat covers (some have separate motor cover).
Size/Fit:
Bimini-Tops must be lowered and stored flat or removed (unless stated otherwise),
Pedestal Seats must be removed or lowered,
Does NOT have or use Snaps or Clips like a factory original Bow, Cockpit or Playpen Cover,
Does NOT FIT THE FOLLOWING UNLESS SPECIFICALLY STATED IN BOAT DESCRIPTION ABOVE: • Other boat models or years (it MAY fit other boats, but NO guarantee of fit), • Wakeboard Tower, • Folded or Upright Bimini-Top, • Radar Arch, • Camper-Top, • T-Top, • Hard-Top, • Ski Tow Pylon, • Non-Integrated Swim Platform, • Bow or Stern Mounted Trolling Motor, • Raised or protruding antennas, brackets, winches, mirrors, rod holders, etc.,
Will NOT fit ANY NON-Factory-Installed Arch, Top or Tower because it may be installed in a different location,
NOT intended for use on a LIFT, as it is difficult to pull the cover back over the transom properly.
Warranty: The materials and workmanship are guaranteed by Carver® to be free of defects at time of manufacture and are covered by Carver's® https://www.carvercovers.com/about-carver/product-warranty-information/ limited warranties: Sunbrella®/Outdura®: 10 years, Sun-Dura™: 7 years. (Note: The use of Bungee Cords instead of Tie-Down Straps on Boat-Covers will void the warranty).
Installation: Cover is rolled and packaged with the bow end of the cover to the outside. The tag on the bow end is sewn into the inside hem of the cover. Start at the bow and follow these instructions: Carver® Boat Cover Installation Instructions.
Carver® has made boat covers in South Carolina, USA for 40+ years:
Sturdy TIE-DOWN-LOOPS (every 2 feet, double sewn in an offset "V" for strength),
RnR-Marine™ is rated 4.07 / 5.0
based on 149
RnR-Marine™ Customer reviews
and 24
Better Business Bureau® reviews