Factory Camper CANVAS (no frame) with zippers for OEM Camper Side and Aft Curtains (not included), SeaMark(r) (or RECwater(r)) vinyl-lined Sunbrella(r) (or RECacril(r)) fabric (Bimini and other curtains sold separately), OEM (Original Equipment Manufacturer) in SeaMark® (waterproof) marine fabric, produced with the same high quality, original - digitized patterns approved by ® for the :
Notes:
- ® Model Specific Details: - ® .
Product Details: The Camper-Top is the single Top canvas piece at the back of the boat (sometimes the front on Bow-Riders or Deck Boats), mounted on a separate Camper-Top-Frame (sold separately) which attaches to the back of a Bimini-Top, Convertible-Top, Arch-Aft-Top, Arch or Hard-Top (other tops sold separately). The Camper-Top combines with Curtains (sold separately) to fully enclose the back of the boat providing full, protected (standup) use of the rear cockpit area at the dock. Factory Original Equipment Manufacturer (OEM) canvas made-to-order and shipped from BLI®.
Included: Single Camper-Top-Canvas piece with Zippers on edges,
NOT Included: Frame, Curtains, Mtg. Hardware, Boot-Cover and other Bimini/Convertible/Arch-Tops and Frames.
® Factory Original Equipment Manufacturer (OEM) Notes: Unfortunately, we do not have any factory OEM canvas for blank® boats.
Size/Fit: Has pockets to fit onto Factory OEM Camper-Top-Frame bows (frame not included). Verify that your old and mating canvas has factory #10 zippers (5 teeth/inch), NOT #8 (6 teeth/inch, which are After-Market zippers). Attaches (typically zips) to the back of a Radar Arch, Bimini-Top, Convertible-Top, Sunshade-Top or Hard-Top (other tops not included). Has zippers along sides and back for Camper Side and Aft Curtains IF offered (not included). ONLY fits Factory Original-Equipment Camper-Top Frame, Sides and Aft Curtains.
Guarantee: RNR-Marine™ and BLI® (the manufacturer) guarantee that our factory original equipment manufacturer (OEM) tops, visors, curtains, bow covers, cockpit-covers, mooring-covers and other factory original-equipment marine canvas:
Will be made using the most current digitized patterns approved by the boat manufacturer for the specified model based on the boat's actual production date identified by the last 4 digits of your Hull-Identification-Number (HIN) (and for Sea Ray® boats: the Sea Ray® Hull-Production-Number located below the HIN on the Starboard side of your transom),
Colors, changes or improvements to fasteners, materials and assemblies will be done for the most part up-to-date for the boat model,
We cannot guarantee fit due to outside installation sources, color or changes that may have been done after the boat left the factory,
Will not have fasteners installed - they are included in a separate hardware pack,
We guarantee the quality of workmanship and materials, and we will resolve quality issues found upon delivery by repairing or replacing (at our discretion) the canvas, frame or cover in question.
Installation: This replacement top canvas does NOT have Zippers at the Frame Bows, so the Frame MUST be removed and taken apart (at one end typically) to replace the top canvas. Canvas and Snap Installation Instructions