TTopCover™ T-Top or Hard-Top Boat-Cover (Elite 9oz./sq.yd. fabric) attaches beneath T-Top or Hard-Top frame to cover entire boat, bow, helm, cockpit and motor(s). Custom patterned for tight fit:
Notes:
Custom patterns for 1,000's of Factory Installed boat T-Tops or Hard-Tops:
Not a Generic pattern like other covers,
We can pattern your boat (no charge) or find one in Charleston, SC if we don't have a pattern for your boat yet,
Connects with straps beneath Top frame and covers entire boat and motors(s),
Our unique design is open under the top to help avoid Mold and Mildew by drawing air in from the sides and around the motor(s), where it warms, rises and passes out the top, removing humidity and moisture (click video at right),
Size/Fit: Patterned for Factory-Installed T-Top or Hard-Top ONLY (NOT After-Market tops) to fit and completely enclose the entire boat and lowered motor(s). Accommodates most factory Bow Rails, Bow Anchor Roller, Power Pole™, Talon™ and Trolling Motor (send photo). Initial installation takes 15-30 minutes to adjust straps to top, and only takes 10-15 minutes thereafter. For boats kept on a Trailer, Lift or Jet Dock (not typically used for boats kept in the water, since there are no openings for cleats, dock lines, raised motors or bumpers),
When ordering, select:
Color,
Zipper Side (from T-Top to Floor): PORT or STARBOARD?
Bow Rails: LOW/NO (Less then 6-inches high), MED (6-10 inches) or HIGH (over 10 inches) factory original equipment bow rails?
Bow Anchor Roller: NONE or WITH bow anchor roller or pulpit?
After ordering, we will send an Order Confirmation Email and ask for:
Photos of Rails, Pulpit or Anchor Roller if you have these,
Motor(s) Model and Size,
Jack Plate? Offset?
Power Pole or Talon? Side? Photo? Power Poles often fit behind the cover, but sometimes need a small cutout or hole to pass through (see photos at right),
Trolling Motor? Quick release for removal? We recommend pulling your trolling motor back into the boat so that the cover does not collect water. If trolling motor is fixed, please buy the Trolling Motor Pocket below,
For Lift or Dry Stack storage, we recommend a Sand-Bag every 6 feet on each side + 2 at rear.
Options:
Bow Anchor Roller, Power Pole and Talon Openings: simply reply to your Order Confirmation Email with Photos,
TTopCovers™ Extended-Skirts, NO LONGER REQUIRED AS OF FALL 2018 since we are modifiying ALL TTopCovers™ to cover the hull sides to avoid Gel-Coat color fading.,
TTopCovers™ Trolling Motor Pocket fits around bow mounted trolling motor (we recommend removing or pulling the trolling motor instead),
T-Top Storage Bonnet is no longer available online due to measurement/fit issues with protrusions
Carver® OVER Top Cover if you want to competely cover the T-Top (or Hard-Top), Boat and Motor.
Warranty:5-year Manufacturer Limited Fabric Warranty. The Elite™ 9 oz. fabric cover should last upwards of 8-9 years. Laportes warrants to the original purchaser of its product that Laportes will repair or replace any products found to be defective in materials and workmanship for a period of one (1) year from the original purchase date. See https://www.ttopcovers.com/support/warranty.
Installation: TTopCover™ Installation Guide and Video
Not what you need? Try
